lumped coefficient

См. также в других словарях:

• Lumped capacitance model — A lumped capacitance model, also called lumped system analysis,[1] reduces a thermal system to a number of discrete “lumps” and assumes that the temperature difference inside each lump is negligible. This approximation is useful to simplify… …   Wikipedia

• Mechanical filter — Figure 1. A mechanical filter made by the Kokusai Electric Company intended for selecting the narrow 2 kHz bandwidth signals in SSB radio receivers. It operates at 455 kHz, a common IF for these receivers, and is dimensioned 45×15×15 mm ( …   Wikipedia

• Smith chart — The Smith Chart, invented by Phillip H. Smith (1905 1987), [Smith, P. H.; Transmission Line Calculator; Electronics, Vol. 12, No. 1, pp 29 31, January 1939] [Smith, P. H.; An Improved Transmission Line Calculator; Electronics, Vol. 17, No. 1, p… …   Wikipedia

• Convective heat transfer — See also: Heat transfer and convection This figure shows a calculation for thermal convection. Colors closer to red are hot areas and colors closer to blue are cold areas. In this figure, a hot, less dense lower boundary layer sends plumes… …   Wikipedia

• Heat transfer — is a discipline of thermal engineering that concerns the exchange of thermal energy from one physical system to another. Heat transfer is classified into various mechanisms, such as heat conduction, convection, thermal radiation, and phase change …   Wikipedia

• Metal-mesh optical filters — are optical filters made from stacks of metal meshes and dielectric. They are used as part of an optical path to filter the incoming light to allow frequencies of interest to pass while reflecting other frequencies of light. Metal mesh filters… …   Wikipedia

• System analysis — See also systems analysis. : MISO redirects here, for the data line see Serial Peripheral Interface Bus. System analysis is the branch of electrical engineering that characterizes electrical systems and their properties. Although many of the… …   Wikipedia

• Bicycle performance — Lance Armstrong in a 2004 Tour de France individual time trial …   Wikipedia

• Scattering parameters — or S parameters are properties used in electrical engineering, electronics engineering, and communication systems engineering describing the electrical behavior of linear electrical networks when undergoing various steady state stimuli by small… …   Wikipedia

• Impedance matching — In electronics, impedance matching is the practice of designing the input impedance of an electrical load (or the output impedance of its corresponding signal source) to maximize the power transfer and/or minimize reflections from the load.… …   Wikipedia

• Power dividers and directional couplers — A 10 dB 1.7–2.2 GHz directional coupler. From left to right: input, coupled, isolated (terminated with a load), and transmitted port …   Wikipedia